基于序列工作点的航空发动机过渡态气路分析参数选择研究

doi:10.13675/j.cnki. tjjs. 190299

推进技术 ›› 2019, Vol. 40 ›› Issue (10): 2175-2182.DOI: 10.13675/j.cnki. tjjs. 190299

基于序列工作点的航空发动机过渡态气路分析参数选择研究

杨锟¹,屠秋野¹,王纬¹,蔡元虎¹

西北工业大学动力与能源学院

发布日期:2021-08-15
基金资助:
国家留学基金留金发[2014]3026国家留学基金（留金发[2014]3026）。

Parameter Selection for Aeroengine Transient State Gas Path Analysis Based on Sequential Operating Points

School of Power and Energy,Northwestern Polytechnical University,Xi’an 710129,China

Published:2021-08-15

摘要/Abstract

摘要： 为了降低由多工作点分析（MOPA）方法的平均效应所产生的气路分析（GPA）系统误差，提出了基于航空发动机过渡工作过程的序列工作点分析（SOPA）技术，并以此为基础提出了一种系统的气路分析参数选择方法。该方法利用连续小波变换对时间信号的增强解析能力，提取待求健康参数在备选测量传感器上的参数特征，实现了在传感器安装受限条件下必要测量参数的选择。通过对SOPA子系统矩阵进行奇异值分解（SVD），获得了在过渡工作过程中不同时间片段上的健康参数可辨识性。针对大涵道比双轴分排涡扇发动机的参数分析结果表明：通过对待求健康参数的敏感性输出信号进行小波分析所确定的最简传感器布局，具备对全部待求健康参数的可辨识性；而以时间片段矩阵的条件数作为判据评估SOPA子系统的参数辨识能力，能够有效地确定具有高可靠性的SOPA时间片段位置，保证了对发动机气路部件健康状态的估计精度。

关键词: 过渡态气路分析;航空发动机;序列工作点分析;小波变换;奇异值分解

Abstract: In order to eliminate the systematic error of Gas Path Analysis(GPA) caused by the averaging effect stemmed from Multiple Operating Points Analysis(MOPA), Sequential Operating Points Analysis(SOPA) is proposed for the first time based on aeroengine transient operating process, based on which a systematic GPA parameter selection method is introduced. This method takes advantage of the enhanced delineation of time signal provided by wavelet transforms to extract health parameter signatures, according to which the least number of requisite gas path sensors is determined, under the constraint of limited measurements. Singular Value Decomposition(SVD) is applied to SOPA subsystem matrices to attain their identifiabilities of the to-be-estimated health parameters. Applications to a high bypass ratio dual-spool separated flow turbofan engine indicate that the irreducible sensor configuration determined by wavelet analysis of output sensitivities is sufficient to identify the deviation of every to-be-estimated health parameter. The condition number of transient snapshot matrix is an effective metric of SOPA subsystem identifiability to determine the optimal position for SOPA application within the transient process, which guarantees the estimation accuracy of engine gas path component health status.

Key words: Transient state based gas path analysis;Aeroengine;Sequential operating points analysis;Wavelet transform;Singular value decomposition

杨锟,屠秋野,王纬,蔡元虎. 基于序列工作点的航空发动机过渡态气路分析参数选择研究[J]. 推进技术, 2019, 40(10): 2175-2182.

YANG Kun¹,TU Qiu-ye¹,WANG Wei¹,CAI Yuan-hu¹. Parameter Selection for Aeroengine Transient State Gas Path Analysis Based on Sequential Operating Points[J]. Journal of Propulsion Technology, 2019, 40(10): 2175-2182.

参考文献

[1] Urban L A. Gas Path Analysis Applied to Turbine Engine Condition Monitoring[J]. Journal of Aircraft, 1973, 10(7): 400-406.
[2] Stamatis A， Mathioudakis K， Berios G， et al. Jet Engine Fault Detection with Discrete Operating Points Gas Path Analysis[J]. Journal of Propulsion and Power， 1991， 7(6): 1043-1048.
[3] Zedda M. Gas Turbine Engine and Sensor Fault Diagnosis[D]. UK: Cranfield University， 1999.
[4] Aretakis N， Mathioudakis K， Stamatis A. Non-Linear Engine Component Fault Diagnosis from a Limited Number of Measurements Using a Combinatorial Approach[R]. ASME GT-2002-30031.
[5] Merrington G L. Fault Diagnosis of Gas Turbine Engines from Transient Data[J]. Journal of Engineering for Gas Turbines and Power， 1989， 111(2): 237-243.
[6] Groenstedt T. Least Squares Based Transient Nonlinear Gas Path Analysis[R]. ASME GT-2005-68717.
[7] LI Y G. A Gas Turbine Diagnostic Approach with Transient Measurements[J]. Journal of Power and Energy， 2003， 217(A2): 169-177.
[8] Urban L A. Parameter Selection for Multiple Fault Diagnostics of Gas Turbine Engines[J]. Journal of Engineering for Power， 1975， 97(2): 225-230.
[9] Stamatis A， Mathioudakis K， Papailiou K. Optimal Measurement and Health Index Selection for Gas Turbine Performance Status and Fault Diagnosis[J]. Journal of Engineering for Gas Turbines and Power， 1992， 114(2): 209-216.
[10] Provost M J. The Use of Optimal Estimation Techniques in the Analysis of Gas Turbines[D]. UK: Cranfield University， 1994.
[11] Espa?a M D. On the Estimation Algorithm for Adaptive Performance Optimization of Turbofan Engines[R]. AIAA93-1823.
[12] Gr?nstedt T U J. Identifiability in Multi-point Gas Turbine Parameter Estimation Problems[R]. ASME GT-2002-30020.
[13] Ogaji S O T， Sampath S， Singh R， et al. Parameter Selection for Diagnosing a Gas-Turbine’s Performance-Deterioration[J]. Applied Energy， 2002， 73(1): 25-46.
[14] Mathioudakis K， Ph Kamboukos . Assessment of the Effectiveness of Gas Path Diagnostic Schemes[J]. Journal of Engineering for Gas Turbines and Power， 2006， 128(1): 57-63.
[15] McCusker J R， Danai K. Measurement Selection for Engine Transients by Parameter Signatures[J]. Journal of Engineering for Gas Turbines and Power， 2010， 132(12).
[16] Sowers T S， Kopasakis G， Simon D L. Application of the Systematic Sensor Selection Strategy for Turbofan Engine Diagnostics[R]. ASME GT-2008-50525.
[17] Borguet S， Léonard O. The Fisher Information Matrix as a Relevant Tool for Sensor Selection in Engine Health Monitoring[J]. International Journal of Rotating Machinery， 2008， (1).
[18] Simon D L， Rinehart A W. Sensor Selection for Aircraft Engine Performance Estimation and Gas Path Fault Diagnostics[J]. Journal of Engineering for Gas Turbines and Power， 2016， 138(7).
[19] Mathioudakis K， Kamboukos P， Stamatis A. Turbofan Performance Deterioration Tracking Using Non-Linear Models and Optimization Techniques[R]. ASME GT-2002-30026.
[20] Doel D L. TEMPER-A Gas-Path Analysis Tool for Commercial Jet Engines[J]. Journal of Engineering for Gas Turbines and Power， 1994， 116(1): 82-89.
[21] Volponi A J. Gas Turbine Engine Health Management: Past， Present and Future Trends[J]. Journal of Engineering for Gas Turbines and Power， 2014， 136(5).
[22] Daubechies I. Ten Lectures on Wavelets[M]. USA: Society for Industrial and Applied Mathematics， 1992.
[23] Danai K， McCusker J R. Parameter Estimation by Parameter Signature Isolation in the Time-Scale Domain[J]. Journal of Dynamic Systems， Measurement， and Control， 2009， 131(4).

基于序列工作点的航空发动机过渡态气路分析参数选择研究

Parameter Selection for Aeroengine Transient State Gas Path Analysis Based on Sequential Operating Points

PDF

可视化

摘要/Abstract

引用本文

使用本文

参考文献

相关文章 0

编辑推荐

Metrics

本文评价